Wiring - Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones

8. Wiring.

CAUTION: Be sure outlet box is properly grounded and
that a ground (GREEN or Bare) wire is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the instructions, please use a qualified
electrician.
Note: Excess lead wire length from the fan can be cut to
the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect BLUE wire from fan to THIRD wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from fan
to BARE/GREEN wire from ceiling with wire connector
provided.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
TO WIRE WALL CONTROL, remove existing wall switch.
[NOTE: Three wires are required in wall in order for wall
control to function properly, i.e., for both fan and light
to work.]
Wire wall control as follows (refer to diagram at right):
Connect BLACK wire with WHITE STRIPE from wall
control to BLACK wire (AC IN L) from outlet box with
wire connector provided.
Connect SOLID BLACK wire from wall control to
BLACK wire from fan in the outlet box with wire
connector provided.
Connect BLUE wire from wall control to BLUE/THIRD
wire (for LIGHT) in the outlet box with wire connector
provided.
Connect GREEN wire with YELLOW STRIPE from wall
control to GREEN/BARE wire in the outlet box with
wire connector provided.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate to wall
control using 2 screws provided with the wall control.
Slide the control knobs on the wall control to "0"
position.
white supply wire
black supply wire
from
ceiling
blue
black
white
white
black
blue
from fan
(wiring for fan)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/bare
blue blue blue
(3
wire)
black black black
black
(AC IN from
breaker box)
(wiring for wall control)
page 6
third wire
connector
wall
control
green with
yellow stripe
blue
rd
(OUT to light)
black (OUT to fan)
black w/white stripe
(TO POWER supply)
ground
(green or bare)
wire
ground
(green
or bare)
*
plate