Canopy Assembly; Light Kit Assembly. Pgs - Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones

9. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
10. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in center of fitter plate with loosened
screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was
just removed and securely tighten all
3 screws with a Phillips screwdriver.
["Light Kit Assembly" continued on next
page.]
canopy
screw
motor housing
fitter plate
page 7
hanging
bracket
screw
canopy cover
motor plate
molex connections