Ch1 Channel Learning; Ch2 Channel Learning - Vimar Elvox ECRU Manual Para El Conexionado Y El Uso

With the receiver in its normal operating state:
- Pressing button P1:
The DL1 LED flashes at high frequency, and the receiver is in the mode for changing the type of output (see point 12).
- Pressing button P1 for 2 sec:
The DL1 LED flashes green, and the receiver is in CH1 channel learning mode (see point 5).
- Pressing button P1 for 6 sec:
the four LEDS DL1 ... DL4 flash green in sequence, and the complete setting of the receiver is saved on the Backup
Memory Card,
if installed (see point 11)
- Pressing button P2 for 2 sec:
the four LEDS DL1 ... DL4 flash red and the receiver is in remote control deletion mode (see point 9).
- Pressing button P2 for 6 sec:
the four LEDS DL1 ... DL4 flash green in sequence, and the complete setting of the receiver is loaded from the Backup
Memory Card, if installed (see point 11).
- Pressing buttons P1 and P2 simultaneously for at least 6 sec:
deletes the learned remote controls entirely (see point 10)

5 . Ch1 ChANNEL LEARNING

The DL1 LED blinks: waiting to receive remote controls to be saved and associated with the output Ch1.
DL1...DL4 green flash: receiving and saving remote control OK.
DL1...DL4 orange flash: receiving an invalid remote control.
DL1...DL4 red flash: receiving a remote control but memory is full (500 codes)
- Pressing button P1 for at least 2 sec:
The DL1 LED goes out, the DL2 LED flashes, and the receiver goes into CH2 channel learning mode (see point 6).
- Pressing button P1 or button P2:
the receiver quits the Ch1 channel learning mode and returns to its normal operating state (see point 4).
- After 15 seconds of inactivity:
the receiver automatically quits the Ch1 channel learning mode and returns to its normal operating state (see point 4).

6 . Ch2 ChANNEL LEARNING

The DL2 LED blinks: waiting to receive remote controls to be saved and associated with the output Ch2.
DL1...DL4 green flash: receiving and saving remote control OK.
DL1...DL4 orange flash: receiving an invalid remote control.
DL1...DL4 red flash: receiving a remote control but memory is full (500 codes)
- Pressing button P1 for at least 2 sec:
The DL2 LED goes out, the DL3 LED flashes, and the receiver goes into CH3 channel learning mode (see point 7).
- Pressing button P1 or button P2:
the receiver quits the Ch2 channel learning mode and returns to its normal operating state (see point 4).
- After 15 seconds of inactivity:
the receiver automatically quits the Ch2 channel learning mode and returns to its normal operating state (see point 4).
EN 9