Technical Specifications Of The Hp Lan Card - HP 10BT/100TX NightDIRECTOR/100 Guia De Instalacion

AMD PCnet-FAST Chip
Flash Support
External Start
Connector
LAN Connection Status
LED (Light)

Technical Specifications of the HP LAN Card

Compatible with ISO 8802.3 and Ethernet standards.
•
Direct interface to PCI.
•
Burst support.
•
32-bit Bus Master architecture with integrated DMA buffer
•
management.
Full duplex.
•
Magic Packet support.
•
Optional Boot PROM for disk-less node application.
•
Automatic port selection.
•
Disk-less node application. This enables booting from a server on the
•
network instead of from a system resource (hard disk, diskette drive
or a CD-ROM drive).
Virus Scan support via the Flash socket (not part of the HP LAN kit).
•
TCP/IP Boot Flash support (not part of the HP LAN kit).
•
RPO (when the PC is turned off) and RWU (when the PC is in sleep
•
mode) signals are supplied through this connector.
There is an LED on the rear of the HP LAN card which indicates the
LAN connection status as follows:
Off - when there is no autonegotiation response (for example, when
•
the LAN cable is not connected to the network HUB).
Blinking - during autonegotiation.
•
Green (ON) - the connection has passed the autonegotiation and a
•
link has been established between the HP LAN card and the network
HUB/Switch.
1 Installing the HP LAN Card
HP LAN Card Specifications
English 15