Adjusting The Fastener Penetration; Clearing A Jam From The Tool - Campbell Hausfeld CHN10302 Manual De Instrucciones

Operating Instructions
Operating The
Stapler
(Continued)
ADJUSTING THE FASTENER
PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so fasten-
ers are driven consistently. Do not
exceed 100 psi.
2. To drive the fastener shallower, turn
the wheel (C) to right to the extent
desired.
3. To sink a fastener deeper, turn the
wheel (C) to left to the extent
desired.
(C)
4. Make sure trigger
and work contact
element (WCE) move
freely up and down
without binding or
sticking after each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is
equipped with an
adjustable direc-
tion exhaust
deflector. This is
intended to allow the user to change
the direction of the exhaust. Simply
twist the deflector to any direction
desired.

CLEARING A JAM FROM THE TOOL

1. Disconnect the
air supply from
the nailer.
2. Remove all
nails from the
magazine (see
"Loading/
Unloading The
Nailer").
WARNING
!
cause the fasteners to eject from the
front of the tool.
3. Undo latch by
pulling out and
down. The wire
latch will disen-
gage from the
hooks on the nose.
4. The door can
now be rotated,
exposing the
jammed fasten-
er.
5. Remove the
jammed fasten-
er, using pliers
or a screwdriver
if required.
movement
6 Rotate door
back
into the closed
position.
7. Extend the wire
latch and place
over the hooks
on the nose.
Rotate
8. Close the latch
by pushing the
latch up and in
until the latch
snaps into place.
9. Make sure the
Technical Support
Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this tool or
for additional copies of this manual.
Fastener And Replacement
Failure to remove
Parts
all fasteners will
!
Hausfeld 18 gauge fasteners (or equiv-
alent - see Fastener Interchange
Information). Tool performance, safety
and durability could be reduced if
improper fasteners are used. When
ordering replacement parts or fasten-
ers, specify by part number.
Tool Repair
Only qualified personnel should repair
the tool and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and acces-
sories which perform equivalently.
Assembly Procedure For
Seals
When repairing a tool, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W non-
detergent oil or equivalent, must be
added through the air line before
testing.
5
CHN10302
trigger and
work contact
element (WCE)
move freely up
and down without sticking or binding.
Use only
WARNING
genuine Campbell
www.chpower.com