Getting St Rted - Black and Decker SPACEMAKER TROS1500 Manual De Uso Y Cuidado

2
CONTROL P NEL
1. Temperature selector
2. Cooking function selector
3. Power ON indicator light
4. TO ST / TIMER selector
Important: When making toast or
using the TIMER function, always
turn the dial past 10 and then turn
back or forward to desired setting.
3
† 1. Mounting Parts
(Part # SDC-MOUNTING KIT)
16 Spacers
4 ½"
4 ¼"
4 "
3
/
16
4
1
/
16"
12 Screws
4 1"
4 1½"
4 2¼"
4 Washers
2. Mounting Template (in box)
† 3. Mounting Bracket
(Part # Part #SDCW-BR CKET)
5

GETTING ST RTED

• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting washers, screws and spacers for mounting and set them

aside in a safe place where they will not roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE LOC TION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.

• DO consider your normal work patterns in the kitchen when choosing
location.
• DO NOT mount over any heating or cooking appliance such as your range or

oven.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light fixtures.

Note: Do not install closer than 4 inches to any vertical surface or to any
horizontal surface beneath the unit.
Note: If you are mounting multiple †SpaceMaker™ appliances, they should not
be mounted flush to one another. llow at least 4" of space between appliances
for adequate cooling.
Caution: This appliance features a Save- -Plug™ outlet receptacle to connect
smaller †SpaceMaker™ appliances such as the mini food processor / grinder or
can opener. Do not use this outlet for any other appliance!
Caution: When selecting a location for your toaster oven, make sure you have
adequate room to reach the Rear Receptacle.
Note: If you are connecting another †SpaceMaker appliance into the Save- -
Plug™ outlet, make sure you can easily unplug the appliance after each use.
DETERMINE C BINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine
if your cabinet has a flat bottom (B) or an overhanging lip (C). If your cabinet is
flat, follow ST ND RD INST LL TION; if the cabinet has a lip, refer to SP CER
MOUNTING INST LL TION.
B C
6