HeatStar ERXL-40 Instrucciones De Funcionamiento Y Manual Del Propietario página 12

FIGURE 6: Typical Suspension Details
Screw Hook Beam
min. 3/8" (10 mm) Clamp
Washer
I-Beam
Locknut
Washer
Wood Beam
As Req'd
Chain kit - Stk. #17370
One chain kit will suspend one 10 ft. section of tube and one 10 ft.
section of reflector.
FIGURE 7: Tube and Reflector Hanger
angle mounting ring
radiant tube
horizontal mounting ring
hanger
reflector
side
below
(
horizontal reflector position standard
A
B
FIGURE 7: Mounting Flange / Tube Detail
1) Insert tube 06413 into front casting to point (A).
2) Tighter all set screws marked (B) until snug.
3) After both set screws are snug, turn each
additional 1/4 turn to secure tube in place.
Concrete
Bar Joist
Clip Beam
Truss
Anchor
S-Hook
top
45° (
reflector position optional
)
B
Enerco | Heatstar ERXL Series Heater
FIGURE 8: Burner Box / Transition Tube Detail
Burner Box
(flame observation
window facing down)
Mounting Flange
Flange Kit #06428XL
Kit Includes: Flange,Screws(4), Lock Washers(4), Gasket(1)
FIGURE 9: Reflector End Cap
)
Parts list
1 00419 Reflector End Cap (Qty 1)
2 09369 Spring Clip (Qty 4)
12
Operating Instructions and Owner's Manual
Gasket
Stk. #12397
Split Lock Washer
Stk. #98527
Cap Screw
Stk. 98012