Silca Tri-Code Manual De Uso página 83

Operating manual - English
T (X)
OP AXIS
1) Turn off the machine and unplug.
2) raise the protective shield.
3) disconnect the top axis connection wire (J1)
from the carriage (fig. 67).
4) remove the top axis cover by unscrewing the 3
fixing screws (B5) and pull out in the direction
shown (fig. 67).
5) disconnect the sensor connector (J) (fig. 68).
6) loosen the grub screw (M2) with the allen key
provided.
7) remove the faulty sensor (M1) and replace with
a new one, turning until it almost touches the
underlying pin (fig. 69). Tighten the grub screw
(M2).
8) connect the sensor connector (J).
9) replace the top axis cover.
10) connect the top axis connection wire (J1) to the
carriage.
M1
Fig. 68
Fig. 69
78
SENSOR REPLACEMENT
M2
Copyright Silca 2006
Fig. 67
X axis sensor
0,1 / 0,4 mm (0.0039" / 0.0157")
TRI-CODE H.S.
B5
J1
J