Fluidmaster K-507A-008 Guía De Instalación Rápida página 7

STEP 5: SECURE TANK TO BOWL
A: INSTALL RUBBER WASHERS
Place one rubber washer on each
tank bolt.
B: INSERT BOLTS INTO TANK
Place tank bolts through bottom
holes of tank.
C: SECURE TANK ONTO BOWL
Set bowl onto tank. Slide one
metal washer onto each bolt, then
loosely tighten hex nuts. Alternately
hand-tighten hex nuts onto each one
of the bolts evenly, then use pliers
to tighten hex nuts until tank is snug
and it does not rock. Do not over-
tighten.
Large Adjustable
Pliers
12
Rubber
washer
Rubber washer
Tank (Omit for
Kohler ® Toilets)
Bowl
Metal washer
Large hex nut
STEP 6:
FINISHING STEPS
A: ATTACH REFILL CLIP TO
OVERFLOW PIPE
Note: If refill tube is too long to fit
inside tank with lid closed, remove
refill tube from fill valve refill port, cut
tube and reattach to port.
Scissors
(Optional)
B: CONNECT FLAPPER CHAIN
Attach clip to the tank lever directly
above the flapper. Leave roughly ½"
of slack (small 'J' shape) in the chain.
C: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right (counterclockwise)
*Hand-tighten only. Do not overtighten.
D: TURN ON WATER
Check for leaks.
E: WATER LEVEL
After the tank stops filling,
water level should fill the
tank to roughly ½" below
top of overflow pipe to
ensure a proper flush.
* Overtightening may damage fill valve or coupling nut, potentially causing flooding.
Make sure the float cup does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
RIGHT
TURN
COUNTER-
CLOCKWISE
Top of Overflow Tube
1/2"
Water Level
Overflow Pipe
13