Product Set Up; Product Use - Nuna aace Manual De Instrucciones

Product Set Up

Installation Concerns
!
DO NOT install this booster on vehicle seats with
Lap Belts only. (1)
!
This booster is suitable for vehicle seats with
a 3-point Retractor Safety Belt. (2) If your
vehicle has ISOFIX Anchor Points, we strongly
recommend that you connect the ISOFIX
connector to the ISOFIX Anchor Points together.
(3)
!
DO NOT install this booster on vehicle seats that
face sideways or rearward with respect to the
moving direction of the vehicle.
!
Please refer to your vehicle owner's manual for
recommended or suggested installation positions.
(4)-1
!
This booster must be installed in the rear vehicle
seat. (4)-2
!
DO NOT install this on movable vehicle seats
during installation.
Seat Assembly
1
- With the seat lying flat, attach the seat back to
the booster seat bottom by hooking the seat back
hooks over the seat bottom as shown. (5)
11
AACE Instructions
2
- Now rotate the seat back up until it clicks into
position and the seat is fully upright as shown. (6)

Product Use

Side Impact Protection (SIP) Pods
1
- To open the SIP Pods pull out on the side tab (7).
2
- To close push button (8)-1 and push in (8)-2.
!
SIP Pods should be deployed whenever the
booster is installed in a vehicle. You may push in
the inboard SIP pod if it interferes with an inboard
passenger.
Height Adjustment for Head Support
1
- The Head Support height can be adjusted for
best fit to your child and proper placement of the
Vehicle Shoulder Belt.
2
- To adjust, squeeze the Head Support Adjustment
Lever, then pull up (9) or push down (10) the Head
Support until it locks into one of the 11 positions as
shown.
!
Before adjusting the head support height have
your child lean forward slightly.
!
As the Head Support is adjusted up, the sides of
the seat automatically move outward to provide
more shoulder room.
12
AACE Instructions