Assembly Instruction - InnovaMaxx SPEED BIKE SX200 Manual De Instrucciones

3. ASSEMBLY INSTRUCTIONS:
1. Preparation
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above of this instruction sheet
you will find an explosion drawing with all single parts (marked with numbers) which this item consists of.

2. Assembly Instruction:

FIG 1
FiG 2
6
FIG.1:
Attach the Front Stabilizer (pt.15) to the Main Frame
(pt.16) using two sets of Ø8 Flat Washers (pt.5), M8
Domed Nut (pt.6) and M8*52 Carriage bolt (3).
Attach the Rear Stabilizer (pt.4) to the Main Frame
(pt.16) using two sets of Ø8 Flat Washers (pt.5), M8
Domed Nut (pt.6) and M8*52 Carriage bolt (3).
FIG.2:
Slide the seat post (12) into the vertical
Seat post (10) , at the desired position, align holes and
fix in place with the Locking Knob (25) and flat washer
(26). Now fix the Seat (13) to the seat post (12) as
shown. Insert the vertical Seat Post (10) into the main
frame (16) and line up the holes. Secure the saddle
in position with the Adjustment Knob (7). The correct
height for the seat can be adjusted after the bike is fully
assembled.