Backyard Step 2 4906 Manual Del Usario página 4

Protrusion Hazard
If threads are exposed, check for correct
hardware. If overtightened, add washers to
eliminate the protrusion.
CORRECT INCORRECT
BOLT
LOCK WASHER
Bolt and T-Nut Assembly
Tap T-nut into the provided hole. Insert your BOLT
bolt through the lock washer and insert into the
provided hole opposite from the T-Nut. Turn
clockwise to thread into T-nut. Do not completely
tighten until instructed.
LOCK WASHER
To help with assembly we recommend sorting your hardware bags with the seven digit alpha-numeric number printed on the bags or by hardware type
LAG SCREW (i.e. bolts, nuts, etc.). Organizing your hardware will make assembly easier.
BARREL NUT
H100545 H100695
LOCK WASHER
Hardware bags are printed with a seven digit
alpha-numeric part number. During assembly you
only need to reference the last three digits of the
part number as noted in each step. This will make
finding the correct hardware easier.
4
BOLT
When removing the wood from the boxes we recommend arranging them by part number before you begin
assembly. This will allow for faster assembly and easily identify any parts that may be missing or damaged.
Proper Hardware Assembly
BOLT
T-NUT
Bolt and Barrel Nut Assembly
LAG SCREW
Insert barrel nut through the lock washer and press
the pair through the provided hole. Insert your bolt
through the second lock washer and insert the pair
into the provided hole opposite from the barrel nut.
BARREL NUT
Turn clockwise to thread into the barrel nut. Do not
LOCK WASHER
completely tighten until instructed.
SCREW T-NUT
H100699
Hardware Identification
Assembly TIps
T-NUT
LOCK WASHER
BARREL NUT
LOCK WASHER
LOCK WASHER
Sorting Hardware
LOCK WASHER
WASHER FLAT
H100706
BOLT WH
011
5/16 x 1-3/4 -182434 (H100011)
BOLT
Sorting Wood
(Example)
BOLT
LAG SCREW
Lag Assembly
Normally there will be a pre-drilled pilot hole on
assemblies that require a Lag Screw. If there is no
pilot hole, line up the two boards as they are to be
attached and use the factory drilled hole as a guide
to drill another pilot hole into the adjoining board.
This will keep the wood from splitting. Only a lock
washer is required for steps with Lag Screws.
BOLT HEX BOLT
H100716 H100718
011
E1
E2
T-NUT
F1
F2
G1
G2
LOCK WASHER
BARREL N
LOCK WASHER
LOCK WASHER
LOCK WASHER
SCREW PWH
H100742
030
(x2)
(x2)