Black+Decker P2G7B Manual De Instrucciones página 4

Connecting the Booster Using the Included Battery Clamps
WARNING: A spark near the battery may cause an explosion. To reduce risk of a spark near the
battery:
1. Position the battery clamp cords to reduce risk of damage by the car hood, doors, or moving engine parts.
2. Stay clear of fan blades, belts, pulleys, and other parts that can cause injury to persons.
3. Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has larger diameter than
NEGATIVE (NEG, N, –) post.
4. Connect the POSITIVE (RED) clamp from the booster to the POSITIVE (POS, P, +) ungrounded battery post.
Connect the NEGATIVE (BLACK) clamp to the negative (NEG, N or –) battery post, the vehicle chassis or
engine block away from the battery. Do not connect the clamp to the carburetor, fuel lines or sheet-metal
body parts. Connect to a heavy gauge metal part of the frame or engine block.
Note:
If the battery clamps are incorrectly connected with regard to polarity, the Operating Status LED Indicator Ring will flash blue and
red alternately to indicate a fault has occurred. Remove the clamps and then reconnect them properly.
5. When disconnecting the booster, first turn off the Main Power Button. Then remove the NEGATIVE black (–)
clamp from the NEGATIVE battery post or the vehicle chassis, and then remove the POSITIVE red (+) clamp
from the POSITIVE battery post. Disconnect the double barrel tip of the Battery Clamp cable from the Double
Barrel Charger Connector. Store the Battery Clamps in a safe place.
FIRST AID
• Skin: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with soap
and water. If redness, pain, or irritation occurs, seek immediate medical attention.
• Eyes: If battery acid comes in contact with eyes, flush eyes immediately, for a minimum of 15 minutes and
seek immediate medical attention.
Read And Understand This Instruction Manual Before Using This Unit.
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Power To Go™ Lithium-Ion Battery Booster. Read this Instruction
Manual and follow the instructions carefully before using this unit.
IMPORTANT Notes:
• Several factors can affect a battery booster's ability to boost a vehicle's battery, including, but not limited to
the size of the vehicle battery, the temperature (hot or cold), whether the battery is damaged or defective, and
whether the booster itself is fully charged.
• The Power To Go™ Battery Booster requires a minimum voltage to detect the correct connection
before it will begin to boost. If the vehicle battery voltage is below approximately 2 volts the battery
booster may not be able to detect connection and may not be able to boost the vehicle. While this
low battery voltage is rare it may occur under extreme conditions.
P2G7B_ManualENSP_061715.indd 6-7
6
FEATURES
MAIN POWER BUTTON
OPERATING STATUS LED INDICATOR RING
AC-DC CHARGING PORT
(UNDER PROTECTIVE
COVER; FOR USE WITH
AC CHARGING ADAPTER)
DOUBLE BARREL
CHARGER CONNECTOR
(CONNECTS TO CLAMPS OR
12V DC BOOSTING/CHARGING CABLE)
12V DC
BOOSTING/
CHARGING
CABLE
BATTERY
CLAMPS
LED AREA
LIGHT
USB POWER/FAULT
INDICATOR
USB/LIGHT
BUTTON
USB
PORT
120 VOLT
AC CHARGING
ADAPTER
7
6/17/2015 10:03:23 AM