Electrical Requirements; Prepare Installation Space - Gaggenau CX491610 Manual Del Usuario

Electrical requirements

You can find the identification plate with the elctrical
specifications on the underside of the appliance. The
junctionbox must be located within 3 feet of the
cooktop connection. It should be easily accessible for
service purposes.
  PD[  PP  )LWWLQJ&RQGXLW  PP
 DSSUR[  PP
&RQQHFWLRQ
Å-´ %R[
&RQGXLW DSSUR[  IW a  PP
Power supply
CX 491 610 Models...
40 Amp circuit breaker
240 Volt, 3 Wire, 60 Hz
208 Volt, 3 Wire, 60 Hz
All with 39" (1 m) flexible conduit (included)

Prepare Installation Space

Create the cut-out in the countertop according to the
installation diagram. The angle of of the cut surface to
the countertop must be 90°.
The lateral cut-out edges must be flat in order to
ensure that the retaining springs are well-positioned
on the appliance. With multi-layered countertops,
secure strips laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
 PLQ  PP
and furniture parts of
DLU FOHDUDQFH
The worktop must be reinforced if it is less than
20 mm thick when installed overlapping or less than
30 mm when installed flush. Otherwise, it is not stable
enough. Reinforcement material used must be
resistant to heat and moisture.
Notes
‒
‒
PLQ

/ " (10 mm).
3
8
The worktop where the cooktop is installed
should be able to support a weight of
approximately 60 kg.
The cooktop levelling should only be checked
after it is installed in the gap for the built-in unit.



¡

[


“

“
PLQ



“
 
“

ƒ
PLQ

PLQ


PP
7