This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS OR CHANGE TO THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must
follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Drivers / Pilotes / Conductores: 8mm | Resistance / Résistance / Resistencia: 32 Ohms Sensitivity / Sensibilité /
Sensibilidad: 96dB ± 3dB Frequency / Fréquency / Frecuencia: 20Hz - 20KHz Working Time / Heures de travail
continuous / Tiempo de trabajo: 15h Charging Time / Temps de charge / Tiempo de trabajo: 1.5-2h
©2019 ZAGG Inc All Rights Reserved / Tous Droits Réservés / Todos los derechos reservados | NASDAQ: ZAGG | MADE IN CHINA / Fabriqué
en Chine / Hecho en China
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by ZAGG Inc is
under license. Other trademarks and trade names are those of their respective owners. Trademarks are property of ZAGG IP Holding Co., Inc.
La marque et le logo Bluetooth® sont des marques déposée de Bluetooth SIG, Inc. et toute utilisation de ces marques par ZAGG Inc est sous
licence. Les marques commerciales sont la propriété de ZAGG IP Holding Co., Inc.