EGO ED0800 Manual Del Operador página 15

3. Attach the front-assist handle and
lower clamp onto the shaft and
secure them by pre-tightening the
four screws. TURN THE FRONT-
ASSIST HANDLE UPWARDS SO THAT
IT POINTS TOWARDS THE TOP OF
THE REAR HANDLE (Fig. 3).
4. Adjust the front-assist handle
position between the rear handle
housing and the warning label on
the shaft, as shown in Fig. 3. The handle should be adjusted so your front arm will
be straight when using the edger.
5. Tighten the four screws with the hex wrench so that the handle cannot be rotated
on the shaft.
56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
3
Warning
Label
Rear Handle
Housing
15