FAS International JUST NOW Manual Del Usuario página 78

34
Command 33 Disabling single coins / banknotes:
This command allows you to perform the two adjustments described below:
1) To block acceptance of particular coins by the coin mechanism.
2) To block acceptance of particular banknotes by the reader.
Pres the ESC button to go from point 1 to point 2.
N.B.: The coins are in order of increasing value.
Command 34 Inhibits Coin inhibition with exact amount:
This command blocks the acceptance of particular coins during small change giving, i.e. when the display
shows the message "insert only exact amount".
1. Go into programming mode to display ..................................................................................... Command 00
2. Key in 34 and press ENTER to display ....................................................................................... Coin No. 00
3. Key in 5 and press ENTER to display .......................................................................................................... 1
4. Key in 0 and press ENTER.
N.B.: To activate the possible modifications of command 33, turn the machine off and then on after
E
modification itself.
N
G
Command 35 Resetting coin meters in change giving tubes:
L
Use this command when replacing token meter or emptying the change giving tubes with the machine off to
I
synchronize the meters with the actual contents of the change giving tubes.
S
1. Programming mode, display views........................................................................................... Command 00
H
2. Key in 35 and press ENTER , display views ................................................................................ Code 0000
3. Key in 6203 and press ENTER.
Command 36 Condition exact amount (no coins available for change):
This command is for setting (for each change giving tube) the number of coins below which the machine can
be considered to be in a condition of „no coins available for change‟. The set value must always take into
consideration the coin minimum level in the tubes (command 32), that is it must be higher than the latter
(example: if command 32 is set at 5, the command 36 values must have a setting of 6 as their minimum
value). The tubes that are not included in this condition must be set at "0".
When the contents of any one of the tubes included in the condition drops below the corresponding set value
the machine displays the warning that there are no coins available for change.
Command 37 Inhibits note validator during exact amount:
Setting this command to 1 during exact amount will inhibit the note validator.
N.B.: If only the note validator is installed, this command has to be set to 0.
Command 38 Emptying of change giving tubes:
This command is used to inventory the coins in the tubes of the coin mechanism. To obtain the allotment
from tube 1 (coins of lower value) proceed as follows:
1. Programming mode, display views........................................................................................... Command 00
2. Dial 38 and press ENTER, display views ................................................................................... Tube no. 00
3. Dial 1 and press ENTER,
The coin mechanism starts giving out coins from the chosen tube until the release of pushbutton ENTER.
Command 39 Filling in of the change giving tubes:
Proceed as follows:
1. Go into programming mode to display .................................................................................... Command 00
2. Key in 39 and press ENTER
3. Insert the coins in the coin mechanism
4. Press again the pushbutton ENTER
N.B. If the procedure is not correctly carried out, you can find wrong values in commands 09 - 10.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
JUST NOW – Issue 00