Kruger KB650-850GT-ET Manual De Uso Y Mantenimiento página 35

−
If parts must be replaced, request ORIGINAL spare parts from a dealer
and/or Authorised Retailer.
−
For all maintenance operations, disconnect the battery.
−
Do not remove the guards which require the use of tools to be
disassembled.
−
Before opening the central upper door to carry out possible operations
inside the machine, switch off the machine using the key and remove it
from the control board.
−
Do not wash the machine with direct or pressurised water streams, or
with corrosive substances.
−
Avoid pouring corrosive liquids such as alcohol, gasoline and acids on
top of the cover of the machine since it can be damaged.
−
The machine should be inspected by an authorised service centre every
200 hours of operation.
−
The machine must never be left unattended, during the scrapping phase,
because of the presence of toxic-harmful materials (batteries, oil, etc.)
which are subject to standards that require disposal in special centres.
−
The machine will not generate damaging vibrations.
No accident prevention programme is effective without the complete
cooperation of the person directly responsible for operating the machine.
Most of the accidents that may occur in a company, on the job or during
transfers are caused by the non compliance of the fundamental safety rules.
A careful and cautious user is the best guarantee against accidents and is
more effective than any type of prevention programme.
While working, please pay attention to the operators who may be found inside
the area to be cleaned and especially to children.
35
KB 650/850 GT-ET