Inserting/Removing Accessories - Nikota 05026 El Manual Del Propietario

Operation (cont'd)

Inserting/Removing Accessories

WARNING! ALWAYS UNPLUG THE ROTARY TOOL BEFORE
CHANGING ACCESSORIES/COLLETS OR SERVICING YOUR TOOL THE
TOOL COULD START UNEXPECTEDLY, CAUSING SERIOUS INJURY.
To loosen the collet nut:
1 Press the shaft lock button.
2 Rotate the shaft manually until the
lock engages and prevents further
rotation.
CAUTION: DO NOT ATTEMPT
TO ENGAGE THE SHAFT
LOCK WHILE THE TOOL IS
RUNNING.
3 Use the wrench to loosen the collet nut by turning in the direction of the
arrow labeled L in the illustration. The collet nut must be loose in order
to insert or remove accessories.
4 Remove the old accessory (if any) and install the new accessory, being
sure to push it as far as possible into the collet.
5 Tighten the collet nut
by hand until snug.
6 Finish tightening the
collet by turning the
wrench in the direction
of the arrow labeled T
in the illustration. Do
not overtighten.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthony94122@outlook.com
Owner's Manual
wrench
collet nut
13
shaft lock
button
T
L
collet