Ce Declaration Of Conformity - stayer CM230K Manual De Instrucciones

HOW TO USE THE RIP FENCE
Using the rip fence will provide more accurate straight cuts
than by cutting free-hand. For installation,
from power source then insert the rip fence in the mounting
slots. In the base. See fig.9 Select the desired cut width on
the cutting guide and tighten the 2 thumb screws to lock.
LOWER RETRACTING BLADE GUARD
Is a safety device important for your protection. Every time
you use the saw, make sure that the guard rotates freely
and returns quickly and completely to its closed position.
Do not lubricate this area. The hub has a dry film lubricated
surface that does not need oiling. Never block or wedge the
blade guard in the open position. Never use your saw if the
blade guard is not in working order.
HOW TO USE THE TOOL
Next we detail the indications for a correct use of CM230K
- There are 2 possible positions for the side handle:
on the blade cover or on the base. When making
bevel cuts, always use the base-mount position
because it it more stable.
- Do not use this tool continuously over 30 minutes.
- Wear safety glasses while using compressed air.
- Do not use cutting fluids or lubricants on the blade.
- Keep the cord away from cutting area to prevent it
from becoming entangled in the workpiece.
- The workpiece should be straight and firmly
clamped. Clamp the workpiece on a rigid support.
- Do not force the cut. Let the saw do the cutting at
the rate of speed permitted by the type of cut and
workpiece.
- Periodically blow out all air passages with dry
compressed air.
- Simply remove the brush caps and withdraw the
old brushes. See fig.12.
(always replace as a pair). Then replace the brush
caps. The carbon brushes are a normal wearing
part and must be replaced when they reach their
wear limit (6 mm)
IMPORTANT
If the replacement of the power supply cord is
necessary, this has to be done by the manufacturer or
their agent in order to avoid a safety hazard.
disconnect tool
See fig.11
Replace with new brushes
See fig.13
ENGLISH
11

CE Declaration of Conformity

We declare under sole responsability that this product is in
coformity with the following standards or standardisation
documents:
IEC 60745-2-5:2006, EN 60745-2-5:2007 according to the
provisions of the directives 2006/42/CE,
2006/95/CE
11
2004/108/CE,
Ramiro de la Fuente
Director Manager