Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
Attach
Handle
You will need two I/2" or 13 mm wrenches to attach the
handle.
I.
Attach handle to right side of generator frame (viewing
unit from front), as shown in Figure 2, with a 60 mm
capscrew,flat washers, nylon washers, and lock nut.
60ram Capscrew
Nut
_Washer
J and o
Braeket
_=_Nylon
Washer
M
_ylon
Washer
_
\ _
HandleBracket
/y\
_
Washer
60ram Capscrew
HandlePin
NOTE: DO NOT overtighten. Handle must be able to
move up and down freely.
2.
Raisehandle and insert handle pin to move generator.
BEFORE
STARTING
THE
ENGINE
Add Engine Oil and Fuel
• Place generator
on a level surface.
CAUTION
• Refer to engine manualfor oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
_
WARNING
Replace "1-I/2"
with "2-I/4"
fuel fill level given in engine manual.
Failure to follow
this instruction may cause fuel to overexpand
and spill from tank.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
Publicidad
Tabla de contenido
