TC Electronic BC208 Manual Del Usuario página 5

8 BC208
BC208 Controls
BC208 uses ¼" speaker connections for both input and link. The ¼" speaker jacks are wired in parallel.
To connect the amp to the cabinet, run a speaker cable with ¼" connectors from the amp output to one of the ¼" jacks.
Then, link to a second cabinet by running another cable from the remaining ¼" jack to the additional speaker cabinet.
!
Make sure to use SPEAKER CABLES and not instrument cables for all connections between the amplifi er and speaker cabinets.
Cabinet Combinations
Though connecting and setting up BC208 speaker cabinets is easy and straightforward, we recommend reading this installation guide before usage.
!
For the safety of your fellow musicians and your own, please address the stability of stacked cabinets and take proper precautions to
prevent the stack from being unstable or tipping over. Also notice that only two cabinets should be stacked vertically.
2x208 speakers 2x210 speakers
stacked stacked
Tremendous Plenty of low-end and
mid-range clarity, power with the precise,
cut and punch fast and defi ned tone
for a tight and usually associated with
articulate sound. 10" speakers.
1x212 + 2x210 410 + 212
For a combination of Cool combination for full
precision, full body and low end, precision and body
even more low-end from
the 2x12" cabinet.
!
Make sure to use SPEAKER CABLES and not instrument cables for all connections between the amplifi er and speaker cabinets.
Please notice the following:
• • Impedance for BC208, BC210, BC212 is 8 Ohm
• • Impedance for BC410 is 4 Ohm
• • BC210, BC212 and BC410 use twist-locking professional connectors for both input and link, and so any connection between these cabinets and
BC208 will require cables with a ¼"connector at one end, and a twist-locking connector at the other end.
All TC ELECTRONIC bass amplifi ers can run two TC ELECTRONIC 8 Ohm cabinets.
Depending on the TC ELECTRONIC amplifi er model, a BC410 (4 Ohm) cabinet can be combined with one or two other 8 Ohm cabinets.
NOTE: Should you by accident connect a non-valid combination of cabinets to a TC ELECTRONIC bass amplifi er, the amp's protection mode may be invoked.
However, the amplifi er will not be damaged.
Specifi cations
Speakers
Type 2 x 8" bass enclosure
Frequency range 70 Hz – 4 kHz; ±3 dB
50 Hz – 6 kHz; -10 dB
Power handling (IEC) 200 W continuous, 800 W peak
Impedance 8 Ω
Sensitivity 93 dB (1 W @ 1 m)
Maximum SPL 116 dB continuous, 122 dB peak
Components TURBOSOUND custom drivers 2 x 8"
Quick Start Guide
Connections
Inputs 2 x ¼" TS
Physical
Cabinet construction 15 mm (5⁄8") plywood, front ported
Tuning 65 Hz
Dimensions (H x W x D) 545 x 262 x 316 mm
(21.5 x 10.3 x 12.4")
Weight 10.4 kg (22.9 lbs)
9