modbar Steam System Guía Sobre El Funcionamiento página 19

1) Cleaning the drain collector
Remove the drain tray grill at least twice a
week and clean.
2) Cleaning the body
Wipe the surfaces with a soft, non abrasive
cloth in the direction of the glazing marks,
if any. Do not use any alcohol or solvents
whatsoever on painted or imprinted parts
in order not to damage them.
3) Water Filter/Softener
Please see the documentation accompanying
the water filter/softener for proper operating
and cleaning instructions.
4) Cleaning the steam nozzles
Steam nozzles must be
immediately after use with a damp cloth
and by producing a short burst of steam
so as to prevent the formation of deposits
inside the nozzles themselves, which may
alter the flavor of other drinks to be heated.
5) Depressurize the steam boiler
Turn the selector in position I then
push down the steam lever in order to
depressurize the steam boiler.
• Steam boiler refresh: to activate this function
you need to push the refresh button (see p.
7, item 6). During this operation the water
from the main supply will come inside the
steam boiler automatically.
Note: Use the refresh button for 2 minutes
at end of the working day at least two times
per week. Push again the refresh button to
stop this function.
• Steam boiler draining: Yearly, we recommend
to fully drain the steam boiler by means of
cleaned the specific ball valve located inside the
module.
IMPORTANT
If the machine has not been used for more
than 8 hours or, in any case, after long
periods of being idle, in order to use the
machine to its full potential it is necessary
to perform some cleaning cycles before
brewing beverages as follows:
- Being careful to avoid burns, turn on
each steam wand for at least one minute.
If the machine is not going to be used
for long periods of time, it is advisable to
follow these safety indications:
- Disconnect the machine from the water
mains or interrupt the water connection
via a mains tap.
- Disconnect the machine from the
electrical mains.
19