Chapter 6: Installing The Seat Ring - 4moms Origami 4M-006-01 Manual Del Usuario

English

Chapter 6: Installing the Seat Ring

Adult Assembly Required
This section deals only with the installation of your
included seat ring. The included seat ring is not
suitable for children under 6 months of age. If
installing an alternate 4moms approved seating
®
accessory, please see the instructions that came
with the accessory.
Step 1: Unfold the base as described on page 14.
Step 2: Take the seat ring by its upper and lower
ends and pull gently until the Telescoping Frame is
fully extended. Fit the Upper Attachment Socket
of the seat ring over the Upper Attachment Hub of
the base, and push to pin into place until it clicks.
Do the same on the lower end. Buckle the seat
restraint strap around the Central Bar (as shown on
page 13).
To detach the seat ring, depress the Release Button
on each of the seat's Attachment Sockets, and pull
each pin out as far as it will go.
Note: The seat ring can also be attached to and
detached from the Origami base when both the
base and the seat ring are closed, but it's harder to
do, so we recommend attaching and detaching
when both pieces are fully open.
12 13