Troubleshooting - Comfort Glow QF4570R Instrucciones De Instalación Y El Manual De Propietario

TROUBLE SHOOTING
PROBLEM
Settings on Control Panel or
Remote Control seems
"LOCKED" or cannot be
adjusted.
The appliance turns off and
will not turn back on.
Remote Control does not
work.
No warm air is coming from
the heater.
The appliance does not turn on
when the button is pushed to
"ON"
Remote Control will not turn
on the appliance when the
power button is pushed "ON".
Display area is blank
POSSIBLE CAUSE
1. The "Child Lock" feature may be activated.
1. The overheat protection device in the
appliance has been triggered.
2. House circuit breaker has been tripped.
1. Low Batteries.
1. The overheat protection device in the
appliance has been triggered.
2. Thermostat is set lower than room
temperature.
1. The overheat protection device in the
appliance has been triggered.
1. The "Child Lock" feature may be activated.
2. Check the light (1) on the control panel
and ensure it is lit up (red).
3. House circuit breaker has been tripped.
Display is designed to go blank after 5
seconds of inactivity.
1. Follow instructions for setting and
unsetting child lock feature.
1. Turn all controls off, unplug the
appliance, allow to cool for 30 minutes.
Check to insure nothing is blocking the
air flow of the appliance, plug back in
and restart.
2. Reset house circuit breaker.
1. Replace the battery in the Remote
Control.
1. Turn all controls off, unplug the
appliance, allow to cool for
30 minutes. Check to insure nothing is
blocking the air flow of the appliance,
plug back in and restart.
2. Push temperature buttons on control
panel or remote control to increase
temperature.
1. Turn all controls off, unplug the
appliance, allow to cool for
30 minutes. Check to insure nothing is
blocking the air flow of the appliance,
plug back in and restart.
1. Follow instructions for setting and
unsetting child lock feature.
2. If the light is not lit up (1) on the
control panel, the appliance needs to be
plugged in.
3. Reset house circuit breaker.
Press any button other than the power
button and window will automatically
display.
9
SOLUTION