Morphy Richards 240002 Manual Del Usuario página 6

TT240002MEE Rev1.qxp_Morphy Richards Instruction Book 04/11/2014 15:27 Page 6
Features
(1) Bread Slots
(2) Bread Carriage Levers
(3) Browning Control
(4) Cancel Switch
(5) Cable Storage (underneath)
(6) Crumb Tray (at rear)
Before first use
• Before using your toaster for the first time, operate the toaster
without bread.
• As with all new electric heating elements, your toaster will emit a
'new' smell when it is first switched on. This is quite normal and
not a cause for concern.
Using your toaster
Place the sliced bread into the Bread Slots (1).
1
Adjust the Browning Control (3) to the desired setting.
2
Lower the Bread Carriage Lever(s) (2). The toaster will begin
3
toasting the bread.
When completed, the Bread Carriage Lever(s) will automatically
4
rise and lift the toast from the toaster.
Checking your toast
During toasting, raise the Bread Carriage Lever(s) (2) to check on
the progress of your bread/toast. After looking, lower the Bread
Carriage Lever(s) to the original position. The toasting time will not
be affected or paused during this process. If the toast is ready,
turn the Cancel Switch (4) clockwise to cancel the toasting
process.
Cancel Switch (4)
If you wish to stop the toasting process, turn the Cancel Switch
clockwise. The heating process will stop and the bread will rise.
Browning Control (3)
Reheat
To reheat already toasted bread, turn the Browning Control to
position 1 and press the Bread Carriage Lever (2) down. Your
toaster will reheat your toast.
Defrost
To defrost frozen bread for toasting, adjust the Browning Control
by increasing the browning level by 1 from your desired browning
level. (E.g. increasing 4 to 5), and lower the Bread Carriage Lever.
This will defrost and toast your bread to the desired level.
6
Removing the Crumb Tray
WARNING: Crumbs will accumulate in the CrumbTrays (6) and
could ignite if not emptied regularly.
1. When the appliance has cooled down completely, tap the sides of
the case lightly to dislodge any crumbs lodged in the Bread Slots
(1).
2. Press the Crumb Trays to unlock and remove from the toaster.
3. Empty the Crumb Trays and replace, push to lock back into place.
IMPORTANT: Never operate the appliance without the Crumb
Trays fitted.
Hints and tips
• In order to achieve uniform browning, we recommend you wait a
minimum of 30 seconds between each toasting cycle, so that the
control can be automatically reset.
• If toasting one slice only, you may need to adjust the Browning
Control (3) to a slightly lower setting. You may notice a slight
variation in toast colour on one side of a single slice.
• When toasting 2 slices it is recommended they are of equal size
and freshness.
• Stale bread toasts more rapidly than fresh bread. Therefore, the
Browning Control should be set at a lower setting than usual.
• All sorts of bread can be used as well as teacakes, small rolls etc.
Slices should not however be so thick as to cause burning or
jamming within the Bread Slots (1).
• If the bread in your toaster becomes jammed disconnect your
toaster at the socket, allow it to cool, then remove the bread.
• Allow the toaster to cool fully before putting away.
• Do not use very thin or broken slices of bread.
• Do not insert other foods that may drip during the cooking
process. In addition to making the cleaning procedure more
difficult, these may cause fires.
• Do not insert (by force) foods that are too big for the slots.
• Do watch your appliance during use.
Care and cleaning
• Before cleaning, unplug your toaster and let it cool down.
• The external part of the appliance must be cleaned with a soft
cloth. Do not use abrasive detergents that can ruin the surface.
• DO NOT IMMERSE IN WATER.
• Regularly, remove the plug from the electrical outlet and empty
the Crumb Trays (6) that are under the appliance.
DO NOTTOUCH ANY PART OFTHETOASTER WITH SHARP
OR METAL UTENSILS, ESPECIALLY INSIDETHE BREAD
TOASTING SLOTS. RISK OF ELECTRIC SHOCK AND DAMAGE
TO THE TOASTER.
5