Installation; Operation - Muskoka 25-900-003 Guía De Uso Y Cuidado

Preparation
Open the unit and check carefully for visible damage. If you have any problems with installation, operation,
missing parts, or damage,please call 1-877-447-4768 for service.
DO NOT dispose of packaging until you are satisfied with your fireplace.
DO NOT return unit to store before calling 1-877-447-4768 for service.

Installation

The Fireplace should be located in an area:
• Out of direct sunlight
• Not susceptible to moisture
• Away from uninsulated outside wall
1. Place the assembled mantel near a 15-amp, 120-volt
grounded electric outlet. Read all instructions before using
this appliance.
2. Place the insert directly in front of the mantel opening.
3. Carefully lift the insert through the center opening in the front of the fireplace. The bottom of the insert has
two foam rubber strips to prevent scratching of the hearth base. Slide the insert back through the opening
until the metal trim makes contact with the front of the mantel.
4. Install the mounting brackets provided with the insert in the pre-drilled holes on the bottom of the
insert (see Figure 2).
5. Carefully position mantel with installed fireplace against wall.
6. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum of 1,875
watts if necessary.
CAUTION: MAKE SURE THAT THE UNIT IS INSTALLED SO THAT THE POWER CORD IS NOT
COMPRESSED AGAINST OR CAUGHT ON THE UNIT OR THE MANTEL AND THAT IT HAS AN
FIGURE 2
6
UNOBSTRUCTED PATH TO THE GROUNDED OUTLET.
Clearance to Combustibles
Sides 2-27/64 in. (61.5 mm)
Floor 0 in. (0 mm)
Top 2 in. (51 mm)
Front 36 in. (914 mm)
Rear 25/32 in. (20 mm)
Wooden Facing
[up to 5/8 in. (16 mm) thick]
ets
Mounting Brack
5/16 in. (8 mm)