Battery Replacement - Muskoka 25-900-003 Guía De Uso Y Cuidado

Operating Instructions (Continued)
The infrared remote control relies on a line of sight and must be pointed at the flame/screen of the fireplace to
work. The remote control unit has the controls required to turn ON/OFF both the main power and the heater. If
you prefer to use the touchpad control on the fireplace unit itself, open the control panel sliding cover to
access the touchpad buttons. The layout of the buttons on touchpads and remote control unit can be seen in
Figures 3 and 5, respectively.
1. Plug your fireplace into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the back screen of the
fireplace.
3. Remove plastic tab from inside battery compartment
to activate remote control.
4. Point the remote control directly at the fireplace
flame/screen and use the buttons to operate the
fireplace.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction
CR2025
RELEASE
1. Main Power Button:
This button supplies power to all the functions of the fireplace. The main power button must be in the ON
position, either from the remote or on the touch pad for the functions to work.
2. Timer Button:
This button controls the timer ON/OFF and 10-time setting from 30 minutes to 9 hours. When the Timer is first
turned on, it will come on at the shortest time setting (30 minutes). Each time the Timer button is pressed, the
time increases 1 hour, up to the longest setting (9 hours). Once the set time expires, all fireplace functions will be
automatically turned off.
3. Flame Control button:
This button controls the brightness of the flame effect with settings at High,
Medium and Low. When the fireplace is first turned on, the flame will come on
at the highest setting. The fireplace will remember the last flame setting used
and in later use the flame brightness will start at that setting, unless power to
the unit has been interrupted. Each time the Flame button is pressed, the flame
brightness decreases. The only way to turn off the flame effect completely is to
turn off the Main Power button.
4. Heater Control Button:
This button controls the heater ON/OFF and 11 temperature modes from 68°F
(20°C) to 88°F (31°C). When the heater is first turned on, it will come on at the
lowest room temperature setting 68°F (20°C). Each time the Heater Control
button is pressed, the temperature set point increases 2°F (1°C), allowing you to
adjust the ambient temperature, up to 88°F (31°C). The fireplace will remember
the last heat setting, and in later use, the heater will start at that setting, unless
power to the unit has been interrupted.
NOTE: To switch between Fahrenheit/Celsius modes see
control panel Fahrenheit/Celsius display instructions.
8
OPEN
PUSH
FIGURE 4
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
(Pull tab)
FIGURE 5
1
2
3
4