Mainstays MS18-D2-1011-02 Manual Del Usuario página 13

11. Refer to the configuration you desired, stack the two units together making sure they are centered
properly and the ends are even with each other.
12. Using the Metal Bracket (6) as a template, mark the mounting hole locations at the joints as show in the
illustration. With an electric drill and 1/16" drill bit (not included), carefully drill into the marked
location about 5/8" deep. Make sure that you will not crack the side edges.
13. To secure the units in place, attach the Metal Brackets (6) over the drilled holes using two 15 mm
Screws (5) per bracket. Tighten all the screws with a Phillips screwdriver.
Assembly Instructions
6
M3.5 x 15 mm Screw
(4 used in this step)
⑤
5
Metal Bracket
(2 used in this step)
13
6
⑥
5