Fellowes Venus 125 Manual Del Usuario página 4

ENGLISH
HOT LAMINATION STEPS
1
1. Please connect the laminator
to the socket using the separate
power cable supplied.
5
COLD
3 5
mil mil
4 7
mil mil
??
HELP? TEMP
5. Confirm your selection by
pressing "Enter" button in the
middle of navigation keys.
Laminator will take a few minutes
for temperature adjustment.
9
9. Place pouch, sealed edge first,
into laminator entry. Keep pouch
straight and use the edge guide
to centre it.
4
2
6
3
mil
6. During warm-up, a "wait"
symbol will appear in the
LCD screen until the required
temperature has been reached.
10
10. To prevent jamming,
immediately remove laminated
item from back of machine. Let
item cool on flat surface for
several seconds.
3
COLD
3 5
mil mil
4 7
mil
mil
??
HELP? TEMP
3. Press Stand-by button at
left of front operating panel to
switch laminator on.
7
COLD 80 100 125 175 ??? EXIT
mic mic mic mic
7. Once temperature is reached,
acoustic beep signal will sound,
a small arrow will flash in LCD
screen and roller symbols will
rotate.
11
11. Before switching off laminator,
feed empty cleaning/carrier sheet
through machine to clean unit.
4
COLD
3 5
mil mil
4 7
mil mil
??
HELP? TEMP
4. Use navigation keys to select
setting for the hot lamination
pouch thickness (3-10 mil) you
wish to laminate.
8
8. While laminator is warming
up, please prepare item you
wish to laminate. Place the item
inside the pouch and centre it
against the sealed edge of the
pouch. To prevent jamming, use
a carrier when item is smaller
than the pouch.