Check The Installation; Removing The Appliance; Conversion To Another Type Of Gas - Gaggenau VG 414 210 CA Instrucciones De Instalación

Check the Installation

Check operation of electric igniters. Check flame
characteristics. Flame should be blue with no yellow
tip.
Yellow Flames:
Further adjustment is required.
Yellow Tips on Outer Cones:
Normal for LPG Gas.
Soft Blue Flames:
Normal for Natural Gas.
If the flame is completely or mostly yellow, verify that
the regulator is set for the correct fuel. After
adjustment, retest.
Some yellow streaking is normal during the initial
start-up. Allow unit to operate 4-5 minutes and re-
evaluate before making adjustments.

Removing the appliance

Disconnect the appliance from the power supply.
Close the gas shut-off valve. Remove the silicone joint
from appliances installed flush. Push out the
appliance from below.
9
CAUTION
Appliance damage! Do not lever out the
appliance at the frame from above.
14

Conversion to another type of gas

This gas stovetop corresponds to the categories
specified on the rating plate. By changing nozzles, it
is possible to convert the appliance to any of the
gases listed on the plate. The conversion kit can be
obtained from our customer service. With some
models, the conversion kit is included in the scope of
delivery.
Only a licensed specialist is authorized to switch the
appliance to another gas type.
Before carrying out the conversion, turn off the
electricity and gas supply.
:
1* $  :&
:
Z
/  PP
Z
Z
Z
Replacing the low -setting nozzles
1 Remove the pan support and all burner parts.
2 Undo the cooktop's fastening screws on the
burners and carefully remove the cooktop in the
upward direction. Unscrew the cover plates over
the spindles.
3 Remove the locking screw of the spindles
between the control knob and gas valve and
extract the spindles from the gas valve. Remove
the cover plate in front of the gas valve.
4 The low-setting nozzles are located in the gas
valve and are screwed in from the front. Turn the
Z
Z
Z
Z
3URSDQH  :&
 $
 PP