Publicidad
9
Steps 9 - 12 may be easier with the unit on its back.
In one of the open compartments, place a L Plastic
Inner Side Panel against an Outer Side Panel, with
the FRONT side (with the grooves) facing the
INSIDE of the unit. Insert the BACK edge first,
tucking it into the back corner, then carefully but
firmly press the front edge into the Outer Side Panel.
Repeat on the other side of the compartment, and in
the remaining compartments.
11
Carefully fold a N Corrugated Divider in half (Hint: if
the folded edge is not well-formed, try folding it in the
other direction). Slide the Divider into the slots in the
Shelves, pressing firmly until the Divider is flush with
the Shelves.
Repeat with the remaining Dividers.
13
Grooves have been provided in the O Trim Strips
to hold paper labels from the P ID Label Sheet.
After separating along the perforations, insert the
label into the bottom groove and, holding the label
in place, run your fingernail across the label into
the top groove.
GROOVES
7131-37: 4 of 4; Rev. 8; 05/03
L
N
P
O
Safco Products Company, New Hope, MN 55428
10
Carefully fold one of the M Corrugated Shelves in
half along the creases. Insert it (with the creased
edge forward) into the bottom pair of slots in the
Inner Side Panels (bend the Shelf slightly to get the
ends into the grooves).
Continue inserting Corrugated Shelves into each of
the remaining sets of grooves.
GROOVES
12
Lay a O Plastic Trim Strip flat against the edge of
a Shelf, with the long leg of the Strip on the TOP of
the Shelf. Press firmly into place along the length
of the Strip.
Repeat for all Shelves.
Set the unit upright.
O
Value Sorter organizers are
also available in 24- and
36-compartment sizes.
Model 7111
24-Compartment
Value Sorter
Organizer
M
Model 7121
36-Compartment
Value Sorter
Organizer
Publicidad
