Maintenance Free Battery - Simplicity SNAPPER LT75 Manual Del Usuario

Assembly
Mount the Grass Bag
1. Mount the grass bag assembly onto the rear
bagger brackets as shown (see Figure 5).
a. Use one hand to grab onto the handle at the
rear of the bag frame assembly.
b. Use the other hand to hold the top bagger
handle and guide the bag frame assembly
onto the rear bagger brackets.
2. When mounting the bagger frame assembly, hold
the bottom of the grass bagger assembly slightly
away from the rear plate.
3. Rotate the grass bagger assembly until it locks
in place.

Maintenance Free Battery

IMPORTANT: Before you attach the battery cables to
the battery, check the battery date. The battery date
tells if the battery must be charged.
1. Raise the seat support (see Figure 2).
2. Remove two screws (1) and battery cover (2)
(see Figure 6).
3. Check the side of the battery (3) for the location of
the battery date.
a. If the battery is put into service before this
date, the battery cables can be attached
without charging the battery. See "Install the
Battery Cables."
b. If the battery is put into service after this date,
the battery must be charged. See "Charge
the Battery."
CHARGE THE BATTERY
WARNING
When you charge the battery, do not smoke.
Keep the battery away from any sparks. The
fumes from the battery acid can cause an
explosion.
1. To disconnect the battery retainer (4), push in on
the lower end of the battery retainer (see Figure 6).
2. Remove the battery (3) from the opening between
the engine and the seat support.
3. Remove the protective cap from the
battery terminals.
4. Use a 12 volt battery charger to charge the battery.
Charge at a rate of 6 amps for one hour. If you do
not have a battery charger, have an authorized
service center charge the battery.
5. Install the battery. Make sure the positive (+)
terminal is on the right side.
6. Connect the battery retainer.
INSTALL THE BATTERY CABLES
WARNING
To prevent sparks, fasten the red cable to the
positive (+) terminal before you connect the
negative (-) black cable.
1. Remove the protective caps from the battery
terminals (see Figure 6).
2. Slide the terminal boot (5) onto the red cable (6).
3. Connect the red cable to the positive (+) terminal
with the fasteners (7).
4. Connect the black cable (8) to the negative (-)
terminal with the fasteners (7).
5. Install the battery cover (2) with the two screws (1).
en
15