Bumper Bar - Baby Trend Sonar TS06 A Serie Manual De Instrucciones

ASSEMBLY

BUMPER BAR

WARNING:
bumper bar to lift or carry seat
with child inside. The bumper
bar is not a carrying handle.
5) • Attach the bumper bar by lining up anchors
with the slots on the seat. Push until it locks
into place (Fig. 5a).
NOTE: The bumper bar must be securely
attached before using this product.
• To detach the bumper bar, press the
release button on the bottom of the bar on
each side, and pull bar out of the anchors
(Fig 5b).
TO ADJUST SEAT
WARNING:
upright position should be
used only for a child that is at
least 6 months old.
6) • Toddler Seat Mode: The seat can be
adjusted into an upright, reclined position.
Push the center button on both sides of the
stroller adaptor to rotate the seat (Fig. 6a).
• Rotate the seat into the desired position
until it clicks into place (Fig. 6b). The seat
can face in either direction, frontward or
backward.
7
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Do not use
Fig. 5a
Fig. 5b
The
Fig. 6a
Fig. 6b
• Buckle the strap located underneath the seat (Fig 6c).
strap, use the hook and loop method through the clip. Pull the strap firmly
and attach.
NOTE: To adjust the recline seat strap, squeeze the adjuster while pulling
downwards or upwards (Fig. 6d).
1
2
Fig. 6c
PARENT PHONE HOLDER
7) • To attach the parent phone holder: Slide
the clip on the phone tab located on the
stroller handle until it's tightly secured
(Fig. 7). To release, simply pull the parent
phone holder upwards.
CUP HOLDER
WARNING:
To avoid
burns, never put hot liquids in
a cup holder. Avoid possible
tipping, do not place more than
1lb. (0.45kg) in a cup holder.
8) • To attach the cup holder: Slide the clip on
the cupholder over the cup holder tab on the
handle bar. Push until firmly in place (Fig. 8).
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
To tighten the
Fig. 6d
Fig. 7
Fig. 8
8