Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Photos Do Not Capture Subject of Interest
•
Check the "Sensor Level" (PIR sensitivity) parameter setting. For warm environmental
conditions, set the Sensor Level to "High" and for cold weather use, set the sensor for
"Low".
•
Try to set your camera up in an area where no heat resources are in the camera's field of
view.
•
In some cases, set the camera near water will make the camera take images with no sub-
ject in them. Try to aim the camera over ground.
•
Try to set camera on stable and immovable objects, i.e.: large trees.
•
At night, motion detector may detect beyond range of the IR illumination. Reduce distance
setting by adjusting sensor sensitivity.
•
Rising sun or sunset can trigger sensor. Camera must be reoriented.
•
If person/animal moves quickly, it may move out of the camera's field of view before photo
is taken. Move camera further back or redirect camera.
Camera stops taking images or won't take images
•
Please make sure that the SD card is not full. If the card is full, camera will stop taking
images. Or user can turn on Cycle Recording to avoid such problem.
•
Check batteries to make sure that alkaline or lithium AA batteries left power is enough for
camera to work.
•
Make sure that the camera power switch is in the "On" position and not in the "Off" or
"Test" modes.
•
When GPRS function is on, there will be around 1 minute interval for camera to send out
photo before camera shooting the next photo. Turn off the GPRS, camera can shoot photos
continuously.
•
Please format the SD card with camera before using or when camera stops taking images.
GPRS version camera stops sending photos to email(s) or mobile(s).
•
Check if the SIM card is out of charge.
•
Check if SIM card in using can work with mobile phone.
•
Check if the signal is too weak or there is no signal covered.
•
Make sure the GPRS setting is right (check the manual)
34
Trouble Shooting
Publicidad
Tabla de contenido
