Before You Begin; Tools And Parts Needed; Parts Included; Installation Accessories - Gaggenau VP 414 611 Instrucciones De Instalación

en-us

Before you begin

Before you begin
T ools and Parts Needed
B e f o r e y o u b e g i n
Phillips Head Screwdriver
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
▯
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.

Parts Included

Installation accessories

VA 420 000 Connection strip for combination with
other Vario appliances in the 400 series
for flush installation
VA 420 010 Connection strip for combination with
other Vario appliances in the 400 series
for surface-mounted installation
VA 440 010 Stainless steel appliance cover
Use the accessories only as indicated. The manufacturer
assumes no liability for incorrect usage of the
accessories.
6

Cabinet Requirements

The distance from the top of the cooktop to the bottom of
cabinets above can be reduced to 24 inch when the
bottom of the wood or metal cabinet is protected by not
less than ¼ inch (6.35 mm)-thick flame-retardant
millboard covered with not less than No. 28 MSG sheet
metal, 0.015 inch (0.4 mm) stainless steel, 0.024 inch
(0.6 mm) aluminum or copper.

Countertop Requirements

9
WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least 1½" (40 mm)
from both sidewalls and at least 2" (50 mm) from
the rear wall.
The countertop must be level and horizontal. The stability
of the countertop must be maintained after the cut-out
has been made.