Help Function - Fellowes Voyager A3 Manual De Instrucciones

CleanMe SYSTEM CHECK
The CleanMe system check warns the user if glue or dirt has built up inside the laminator. Glue can build up inside every lamina-
tor, especially when low-cost laminating pouches are used. We recommend using Fellowes brand pouches to reduce the amount
of cleaning required and to get the best laminating quality.
The LCD screen will show the CleanMe sequence to guide you through the steps of the Cleaning process.
1. Warning sequence above shows that laminator needs cleaning. Machine might need to cool down if it has been
laminating before. This can take up to 30 minutes.
2. Open the laminator as described in "Maintenance" on previous page.
3. To clean residue off laminator mechanism, please only use Fellowes Laminator wipes (item No # 57037). Do not use
sharp objects to clean laminator.
4. Please remember to re-secure the mechanism again before closing cover to ensure safe operation.

HELP FUNCTION

The Help function displays in a simple pictorial sequence how to laminate with the Voyager laminator. For further help please
consult 'Troubleshooting' at the end of this user manual or contact Fellowes customer service.
To see how to laminate with
the Voyager laminator select
'Help' in start-up menu with
navigating buttons and confirm
selection with OK (within 5 sec.
of turning laminator on).
AUTO REVERSE AND OVERLOAD PROTECTION
An internal sensor automatically identifies mis-feeds, items that are too thick or jams and reverses machine so items can be
taken out again. This screen sequence shows that inserted item was too thick for laminator.
Item will be ejected out of the front of the laminator again to prevent jams and damage to item and laminator.
8
A)
LCD screen will show simple pictorial sequence of how to laminate with the Voyager laminator in
the 3 operation modes in this sequence:
A) AutoSense mode
B) Manual mode
C) Refer to this user manual for further information
B) C)