Siemens Gigaset SE505 Guia De Manejo Rapida página 23

Setting up the LAN connection
You can connect wired or wireless PCs to your Gigaset SE505 dsl/cable to create a local
network (LAN).
Wireless
◆
A wireless connection is set up using a wireless network adapter that must be
installed in your PC. This can be a Gigaset PC Card 54, Gigaset PCI Card 54 or other
802.11g or 802.11b compatible wireless network adapter.
A wireless network is defined by assigning an identical SSID to all the devices. You
should therefore enter the router's SSID in your network adapter configuration. The
factory set SSID for the router is ConnectionPoint.
If you use a Gigaset PC Card 54 or Gigaset PCI Card 54, enter this SSID using the
Gigaset WLAN Adapter Monitor. Please refer to the relevant operating instructions
for further information.
Provided the correct SSID has been entered in your PC's wireless network adapter,
the wireless connection will be established automatically once you connect the
router to the power supply (see page 22).
Wired
◆
Use the Ethernet cable supplied to connect one of the LAN sockets (LAN1 – LAN4)
on the back of the Gigaset SE505 dsl/cable to the Ethernet network card in your PC.
PC with
Gigaset PCI
Card 54
PC with
Ethernet
card
The graphic shows the various connection options. You should however connect only
one PC to the router and then continue with the following steps. (If you wish to connect
more PCs, please turn to page 28.)
Wireless
Wired
Quick Installation Guide
Notebook with
Gigaset PC
Card 54
Wireless
Notebook with
Ethernet card
21