Kalorik USK JK 34446 Manual De Instrucciones página 3

Fax +1 305 430 9692
ammonia or any other substance that might damage your
health.
17. Do NOT use an abrasive cleaner to clean the inside or outside of
the kettle, to avoid permanent damage to the surface.
18. Ensure that the kettle is properly located on the power base
before switching on.
19. Do NOT refill with water while the appliance is switched on.
20. Remove the kettle from power base before filling or pouring. If the
base becomes wet, unplug the kettle from the power outlet and
switch off. After it has become dry, you may replace the kettle on
the base, after ensuring that the kettle is switched off.
21. Use the kettle only with the power base supplied and vice versa.
22. Use on a hard, flat level surface only.
23. If the kettle is overfilled, boiling water may be ejected.
24. Extreme caution must be used where handling or moving kettle
and pouring from the kettle containing boiling water.
25. Make sure that the lid and the filter are correctly and securely
fitted before switching on the appliance. Failure to do so will
cause the kettle not to switch off, and boiling water might eject
through the spout causing scalding or injuries.
26. When pouring a large quantity of hot water, pour slowly and do
not incline the kettle past the horizontal line to avoid burns and
injuries
27. When you are done using the appliance, switch it off and unplug
the power cord from the wall socket.
28. NEVER use the appliance to boil anything other than water.
29. NEVER use near a flame or hot surface.
30. NEVER put any part of the hand or body near the appliance
when switched on. Steam is invisible and will cause scalding or
injury.
31. NEVER use the appliance if it has been dropped on the floor or
damaged in any way.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
3
Assembly page 3/24
special instruction from Team
Print only
USK JK 34446 - 111026