Fax +1 305 430 9692
BEFORE THE FIRST OPERATION
For the perfect taste, operate the cordless water kettle with fresh
water in order to clean any residue left from the manufacturing
process. When the appliance has cooled down, repeat the process
3 times with fresh water, before rinsing.
OPERATION
Always remove the kettle from the power base (1) before filling it
•
or before any operation.
Open the lid (5) by pressing on the lid release button (4) and fill
•
the tank with fresh water, paying attention not to fill under the
minimum mark and above the maximum mark indicated on the
water window of the kettle (7).
Close the lid by pressing it down until it you hear a click. Make
•
sure it closes correctly.
Make sure the spout filter is well in position, as else the auto-shut
•
off feature would not work.
Put the kettle onto the power base (1), plug into the wall socket,
•
and switch on (2). The pilot light (8) will come on, indicating that
the appliance is operating. If it does not come on, check if the
kettle is correctly positioned on the base and check if the base is
plugged in. Do not open the lid while the water is heating or
boiling.
The cordless water kettle will switch off automatically when the
•
water has boiled. However, you can stop the appliance anytime
by putting the switch in off position or lifting the kettle from the
power base.
CAUTION: Make sure that the lid is closed and the filter is correctly
and securely fitted before switching on the appliance. Failure to do
so will cause the kettle not to switch off.
For instant re-boiling, wait until water has cooled down and
•
switch on the appliance again.
The kettle will not re-boil until the switch is pressed again.
•
The kettle may be stored on the power base when not in use.
•
Always disconnect the power supply when not in use.
•
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the
frame.
5
Assembly page 5/24
special
instruction
from
Team
Print only
USK JK 34446 - 111026