miniland baby warmy twin Manual Del Usuario página 16

ENGLISH
VOLUME IN THE BABY
BOTTLE
180 ml
210 ml
240 ml
270 ml
300 ml
330 ml
IMPORTANT: By following the instructions of the tables, the temperature should
vary between 70°C and 80°C after heating. However, variations in the material,
shape, size, etc. of the receptacle as well as any other conditioning factor, could
cause the final range of temperatures to vary.
11. Once the heating process has been completed, the device will beep to notify the
user that the heating process has finished.
NOTE 1: If there is not enough water in the receptacle for the time set during the
heating process, the device will beep intermittently.
If you pour water in the tank again after three minutes, the device will start up again
automatically.
Take into account that after the process has finished, the bottles/jars of baby food might
not be at the exact temperature you want because of the interval in which the device
has not heated up the containers.
NOTE 2: When heating jars of baby food, stir the baby food with a small spoon for 15-
20 seconds after completion so that the temperature is evenly distributed throughout
the contents.
5.3. FUNCTION 2: TEMPERATURE HOLD AND DEFROST
With this function, the device is able to slowly heat or defrost one or two receptacles to
a set temperature and then keep them there.
In order to proceed with the heating, follow the steps detailed below:
1. Place the device on a suitably flat surface, making sure that it is out of the reach of
children.
2. Insert the AC plug (4) into an electrical socket.
3. Subsequently, add enough water to the tank to cover the receptacles halfway up
their contents.
4. Insert the heating basket (5) into the main body as well as any receptacles which
you wish to heat.
IMPORTANT: Always use the heating basket. The baby bottles or jars of baby
food must never come into direct contact with the heater, since this could mean
that heating is not optimal and the baby bottle/jar of baby food could be damaged.
5. Place the hood (6) over the main body of the device.
6. Select the temperature hold/defrost function (9) on the device and increase or
decrease the temperature until you reach the value to which you wish to heath your
baby bottles/jars of baby food. After five seconds, the green light will change to red,
meaning that the device has started the heating cycle.
WATER IN THE HEATER
75 ml
75 ml
80 ml
80 ml
80 ml
85 ml
16
HEATING TIME
11'
12'
12'
12'
13'
14'