Delete All; Alarm Function - JCM ACCESS - 1000 Manual Del Usuario

4- EVENTS
Allows for events to be displayed and deleted.
4.1 SHOW EVENTS
This shows the date and time of the event, the type of event and the code and number of the last event. Using é ê, all of the
events can be displayed, moving around by number of events.
# DATE
TYPE OF EVENT
Display Type of event
C00 No event
C01 Channel 1 reception
C02 Channel 2 reception
C03 Channel 3 reception
C04 Channel 4 reception
C08 Attempt at radio programming
C09 Anti-panic enabled
C10 Alarm function enabled
C11 Code already entered or exited
C12 Code not programmed or disabled
To exit the menu, press ESC.

4.2 DELETE ALL

Press INTRO and the controller will totally reset the events card and the message OPERATING will appear on the screen. Once the
operation is complete, OK will appear on the screen.
If no action is made, the equipment will automatically exit programming after 60 seconds and two short sound signals are given.

ALARM FUNCTION

This function is only configurable using the Assistant programming tool and is only available on proximity elements where the alarm
function is implemented.
Allows for the enabling of a different relay to that programmed by default, reading the device a certain number of consecutive times
in a maximum time of 5 seconds between each reading.
Example: the proximity element enables relay 1 by default and with the alarm function it will enable relay 3 on reading the device
4 consecutive times.
MESSAGES
Display Type of message
NO This appears when a code that is not programmed or that is disabled in the controller is enabled
DATE This appears when a proximity element is used outside its validity period.
NO CREDIT This appears when a proximity element is used when no credit is available.
NO APB This appears when the anti-passback does not allow access
TIME...... ..
CODE > EVENT No..
24