Operation; Important Safety Instructions - Craftsman 139.53960SRT Manual Del Propietário

OPERATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of severe injury or death:
1. READANDFOLLOW ALL WARNINGS AND
INSTRUCTIONS.
2. ALWAYSkeepremote controls out of reachof children.
NEVER permitchildren to operateor play with garage
door control push buttons or remote controls.
3. ONLYactivategaragedoor when it canbe seenclearly,it
is properly adjusted,and thereare no obstructionsto
door travel,
4. ALWAYSkeepgaragedoor in sight until completely
closed.NOONESHOULDCROSS THE PATH OFTHE
MOVINGDOOR.
5. If possible,use emergencyreleasehandleto disengage
trolley ONLYwhen garagedoor is CLOSED. Weak or
broken springs or unbalanceddoor could result Ln an
open door falling rapidly and/or unexpectedly.
6. NEVERuseemergencyreleasehandle unlessgarage
doorway is clear of persons andobstructions,
7. NEVERusehandleto pull garagedoor open or closed. If
ropeknot becomesuntied, you could fall.
8. If one control (force or travel limits) is adjusted,the
other control may also needadjustment.
9. After any adjustmentsare made,the safety reversal
system MUSTbe tested.
10. Safetyreversalsystem MUSTbe testedevery month.
Garagedoor MUSTreverse on contact with one-inch
high object (or a 2x4 laid flat) on the floor.
11. ALWAYS KEEP GARAGE DOORPROPERLY BALANCED
(seepage3), An improperly balanceddoor maynot
reversewhen requiredand could result in severeinjury
or death.
12. All repairsto cables,spring assembliesand other
hardware,all of which are under EXTREME tension,
MUSTbe madeby a traineddoor systemstechnician.
13. ALWAYS disconnect electricpowerto garagedoor
openerbefore makingany repairsor removingcovers.
14 SAVETHESE INSTRUCTIONS.
Using Your Garage Door Opener
Your opener and hand-held remote control have been
factory-set to a matching code to operate with the
large push button. Your opener will operate with as
many as four "SRT" (Smart Receiver/Transmitter)
hand-held remote controls and one Multi-function
Keyless Entry. However, you can use either of the
two small buttons, if you prefer. And, the 3-function
remote control can also activate additional garage
door openers and/or light controls. If you purchase a
new remote, or if you wish to deactivate any remote,
follow the instructions in the Programming section.
Activate your opener with any of the following:
• The hand-held Remote Control: Hold the large
push button down until the door starts to move.
• The wall-mounted Door Control: Hold the push
button down until the door starts to move.
• The Keyless Entry (See Accessories): If supplied
with your garage door opener, it must be
programmed before use. See Programming,
When the opener is activated (with the safety
reversing sensor correctly installed end aligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door wig stop.
4. If the door has been stopped in a partially open
position, it will close.
5. if obstructed while closing, the door will reverse. If
the obstruction interrupts the sensor beam, the
opener light will blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door wig not close when the beam
is broken. The sensor has no effect in the opening
cycle.
If the sensor is not installed, or is misaligned, the
door won't close from a hand-held remote. However,
you can close the door with the Door Control, the
Outdoor Key Switch, or Keyless Entry, if you activate
them until down travel is complete. If you release
them too soon, the door will reverse.
The opener light will turn on under the following
conditions: when the opener is initially plugged in;
when power is restored after interruption; when the
opener is activated.
It will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Premium Control Console is activated. Rulb size is
75 watts maximum.
31