Description Of The Device; Front Panel; Rear Panel - HQ-Power VDP575MHW16 Manual Del Usuario

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Fitting the lamp
To insert the MSR575/2 lamp loosen the lamp cover at the rear of head ( see the picture ) by removing the 3
fastening screws witch are marked "X, Y, Z". Carefully pull out the cover with the lamp socket assembly. If changing
the lamp, remove the old lamp from the socket and insert a new lamp into the socket. Do not install a lamp with a
higher wattage! A lamp like this generates temperatures the device is not designed for. Please follow the lamp
manufactures notes! Do not touch the glass bulb with bare hands during the installation! Make sure that the lamp is
installed tightly into the lamp holder system. Close the lamp cover and tighten the 3 screws.
b) Lamp adjust
The TARGER 575 lamp holder is aligned at the factory. Due to differences between lamps, fine adjustment may
improve light performance. Strike the lamp, open the shutter and the iris. Set the dimmer intensity to 100% and focus
the light on a flat surface. Centre a hot spot (the brightest part of the image) by using the 3 adjustment screws "A, B,
C". Turn one screw after another a quarter-turn Clockwise or counter-wise .If you cannot detect the hot spot adjust
the lamp until the light is evenly distributed.
c) Description of the device
1. moving head
2. yoke
3. carrying handle
4. base

FRONT PANEL

5. power switch
6. DMX output
7. DMX input
8. power cord
9. fuse holder

REAR PANEL

10. MODE button
11. ENTER button
12. UP button
13. DOWN button
14. display
VDP575MHW16 2 HQ POWER