Heath Zenith SL-6168 Manual De Instalación página 2

Important considerations: The sensor/transmitter must be mounted to the
door jamb. The magnet should be attached to the door. To prevent vandalism
and increase battery life, the sensor/transmitter should be installed inside.
Install an alkaline type A23 12 Volt battery. The positive terminal should be
positioned as shown.
Alignment Marks
The edge of the magnet must be within 2 (13 mm) in. of the edge of the
transmitter, the alignment marks must be positioned as shown, and the front
surfaces of the magnet and transmitter should be as nearly flush with each
other as possible. It may be necessary to use the spacer under the magnet
to obtain the correct spacing.
Use either screws or double-sided tape to mount the magnet
and transmitter.
Installation
To install the battery in the transmit-
ter remove the back of the case
by pushing in the tab on the bot-
tom with a small screwdriver
and rotating the blade.
Test the location of the sensor/transmitter. Hold
the transmitter on the door jamb with one hand,
and the magnet with the other as shown. Take
the magnet away, and the chime should sound.
Attach the back of the case to the door jamb or wall. Snap
the front of the transmitter and magnet back on.
When attaching the magnet or transmitter
using the double-sided tape, make sure the
surface is clean.
-2- 595-5724-03