Ventilation Mode; Air Recirculation - Valeo SMARTSPHERE 200 Manual Del Propietário

AIR CONDITIONING OPERATION
1.3- Drive the SC600 Controller
To turn on the controller, press the "ON / OFF" key, if ignition key is on too. The
display will show the interior temperature and the Set-point.
While the controller is turned on the fan is enabled.
The cooling and heating functions only work with the motor in operation.
The configuration saved at the time the controller is turned off will remain and
be automatically reloaded at the moment it is reconnected.
The controller can be turned off by pressing the "ON / OFF" key.

1.4- Ventilation Mode

When the controller is on, the ventilation fan is kept on level three. Then to
disable the fan you need to disable it manually.
When the AUTO mode is enabled, the ventilation speed control will be set
automatically according to the set-point temperature.
However, AUTO mode, you can manually change the speed pressing the
ventilation button.
The cooling / heating functions work with at least level two of speed.
To return the ventilation to automatic control (when the AUTO mode is enabled)
hold the fan key pressed for a few seconds until the indication of fan speed on
the display is no longer displayed and the LED next to the button get turned off.
- Manual adjustment of ventilation speed:
The fan has 10 levels of speed adjustment.
Adjusting the fan speed:
Press the "Fan" key and the LED next to the button will flash for three seconds
and the fan / ventilation control bars will appear on the display.
The speed setting can only be done while the LED is blinking, using "UP" and
"Down" keys.
After the LED stops blinking the speed is selected. For a new change speed, press
the fan button fast.
While the speed indication appears on the display and the LED next to the fan
button is on, then the ventilation speed control is being manually controlled.
To disable the manual fan control, press the fan button for a few seconds, until
it no longer appears on the display and the LED turns off.
In this condition the fans return to automatic speed control.

1.5- Air Recirculation

The air renewal is controlled completely manually, according to the operator.
The air inlet is closed if the LED next to the button is on and the enabled
recirculation symbol is displayed.
The renewal is closed if the controller is turned off.
It will remain closed while the controller is off.
1.6- Failures
In case of system failures, the display will show (
If the symbol is blinking, there is a fault. But if it is being displayed continuously
means that there was a failure, so it is not present at the moment.
The vehicle must be taken to an authorized service station to get a diagnosis and
solution.
SMARTSPHERE 200
).
31