Descargar Imprimir esta página

Roger Technology AG/BLED Serie Instrucciones Y Advertencias Para El Instalador página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
4
Installation
Remove the top cap of the barrier, lay it upside down
on a stable surface, taking care not to scratch it.
The AG/BLED kit has the electronic boards are
already configured to flash and mounted inside the
transparent shells.
If instead you need to configure and assemble
electronic boards:
• on all MASTER make sure that the jumper is in
position LAM (figura 1, detail A).
• Secure the boards in the shell as shown in figure
3. Warning, the direction of the assembly of
boards varies according to the position, carefully
follow the drawing, if they are mounted differently
the wiring will result short.
• Close the shells.
Before fixing the shells to the cap of the barrier
connect the boards to each other as shown in figure
2. Connect the light unit so obtained to the cable C.
Fix the shells on the cap of the barrier as shown in
figure 3, carefully follow the drawing.
Open the box of the control unit and connect to the
LED LIGHT (figure 2, dettaglio D) the cable indicated
by the letter E.
Configure the parameter
in extended mode) on the control unit to change
the switching on mode, refer to the manual of the
control unit. WARNING! The parameter must not be
00
set to the value
(the lights must not remain solid
on).
Close the box of the control unit
Connect the cable C to the cable E (figure 2).
Position and secure the top cap of the barrier.
5
Testing
Operate the barrier and make sure the LEDs
operation on the cap is intermittent.
Check for the switching on of all LEDs.
-7
in simplified mode (
6
Maintenance
Perform scheduled maintenance every 6 months by
checking the cleanliness and operation conditions.
If there is dirt, moisture, insects or other, turn off
the power, disconnect the batteries (if installed) and
clean. Again perform testing.
In case you notice oxide consider to replace the part.
7
Disposal
The product must always be uninstalled by qualified
personnel using the appropriate procedures for the
correct removal of the product.
This product comprises various types of materials,
some can be recycled others must be disposed of
through recycling or disposal systems provided by
local regulations for this product category.
This product may not be disposed of in household
rubbish. Perform a separate collection for disposal
according to the methods provided by local
regulations; or by returning the product to the seller
when purchasing a new equivalent product.
Local regulations may include severe penalties in
the event of improper disposal of this product.
Warning: some parts of the product may contain
toxic or hazardous substances, if dispersed they
could cause harmful effects to the environment and
human health.
78
5

Publicidad

loading