Black Diamond SA Instrucciones De Uso página 3

step through the waistbelt and into the leg loops (b) and pull them up.
The "Black Diamond"(c) logo should be on your right leg, right side up.
There should be no twists in the belay loop (a), the leg loop cross-piece
(d), or the rear straps (e).
2. Tighten the waistbelt and, if
present, the leg loops by pulling
the webbing tail (f) away from
the buckles (k and m) until
comfortably snug. Thread the
webbing tails into the belt loops
(g). The Speed-Adjust buckles
come pre-threaded and should
only require re-threading if taken
completely apart. Follow Figure
3 to complete re-threading.
3. The waistbelt must fit snugly around your waist. It should ride below
your rib cage and above the top of your hipbone. The leg loops should fit
snugly but shouldn't restrict movement.
4. At least 8 cm (3 in) of webbing tail must extend from both waistbelt
buckles and both leg loop buckles after they have been adjusted correctly
(see Figure 3).
SIZING PRECAUTIONS
It is essential that you wear the correct size and that your harness fits you
◆
well. Before using your harness, hang in it from a safe place to ensure
you've chosen the correct size and adjusted it for a comfortable fit.
The size designation and circumference range (in centimeters and in
◆
inches) of Black Diamond harnessess are located on the RN label on the
harness waistbelt.
k
f
Figure 2
Figure 3