Lavor VAC20X Manual Del Usuario página 10

EN
INSTAllING & ClEANING FOAm SlEEVE FIlTER
INSTAllING FOAm SlEEVE FIlTER
Verify that the power cord is disconnected
•
from the outlet
Remove power head and place in upside down
•
position. Follow instructions to remove cartridge filter.
Carefully slide foam sleeve filter down over the
•
filter cage making sure the whole cage is covered.
Replace the power head on to the container.
•
ClEANING FOAm SlEEVE FIlTER
With the removed power head in the upside
•
down position, carefully remove foam sleeve filter.
Use a mild soap and water solution to wash foam
•
sleeve filter and rinse with clean water.
Allow filter to air dry before installing and using
•
again.
7.300.0342-00_C_Vac15-20-30 ---.indd 10
INSTAllING & ClEANING DUST FIlTER
INSTAllING DUST FIlTER
Verify that the power cord is disconnected
•
from the outlet.
Remove power head and place in upside down
•
position. Follow instructions to remove cartridge filter.
Slide dust filter down over the filter cage making
•
sure the whole cage is covered.
Replace the power head on to the container.
•
REmOVING & ClEANING DUST FIlTER
With the removed power head in the upside
•
down position. Carefully remove the dust filter from
the filter cage. Clean the filter by gently tapping or
brushing dirt off. Cleaning should not be done indo-
ors in living areas.
Use a mild soap and water solution to wash dust
•
filter and rinse with clean water.
Allow the wet filter to air dry for 24 hours before
•
installing onto the filter cage.
10
20-04-2010 10:36:03