Lavor VAC20X Manual Del Usuario página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
sockets which are connected in series with
a ground fault circuit interrupter. In case of
doubt, consult an electrician.
Periodically examine the mains cable
and machine for damage. If any damage is
found, do not use the appliance but contact
your service centre for repair.
Should extension cables be used, ensure that
these lay on dry surfaces and protected against
water jets.
Before vacuuming liquids, check the float
functions correctly.
If the equipment should overturn it is
recommended that the machine should be
stood up before switching off.
If foam/liquid should come from the machine
exhaust switch off immediately.
The equipment should not be used to pick
up water from containers lavatories, tubs, etc.
(see "lIQUID SUCTION")
Aggressive solvents or detergents should
not be used.
Service and repairs must be carried out by
qualified personnel only. Only use manufacturer
original spare parts for service repair.
The manufacturer cannot be held
responsible for any damage/injury caused to
persons, animals or property caused by misuse
of the appliance, not in compliance with manual
instructions.
DRY SUCTION
Do not use the machine without proper
filters.
7.300.0342-00_C_Vac15-20-30 ---.indd 9
lIQUID SUCTION
Do not use the machine without proper fil-
ters.
When vacuuming large quantities of liquid
from a sink or tank etc., do not immerse the noz-
zle completely into the liquid, leave a gap at the
top of the nozzle opening to allow for air inflow.
The machine is fitted with a float valve that stops
the suction when the tank reaches its maximum
capacity. An increase in motor speed will be no-
ticed. When this occurs, turn off the machine,
disconnect from the power supply, remove the
head from the tank and empty the liquid into a
suitable receptacle or drain. To continue vacuu-
ming, refit the head and proceed. After wet vacu-
uming, turn the machine off and remove the plug
from the power supply. Empty the tank and cle-
an/dry the inside and the outside before storage.
blOWER
3
9
EN
20-04-2010 10:36:01

Publicidad

Tabla de contenido
loading

Tabla de contenido